|
 |
 | |
|
|
|
| |
|
|
| |
| ||
|
|
| |
|
|
| |
|
|
Home > Enclosure > Cladding > Flat or Shaped Sheet Cladding > Fibre cement flat sheet cladding Titan® Façade Panel On CLD® Structural Cavity Battens Titan Façade Panel provides a smooth, clean, uncluttered exterior finish. It allows you to create a commercial or even semi-industrial look that’s ideal for modern-style homes. Titan Façade Panel was developed to provide the scope for innovative architectural design while ensuring longevity.CLD® Structural Cavity Battens are an alternative to traditional timber battens used with the installation of Titan Façade Panel. Due to its composition and stability, the batten acts as a structural element when fixed to the framing.
View Product Certifications
When installed as per the Titan Façade Panel on CLD® Structural Cavity Batten technical specification it provides a durable, expressed joint panel appearance for residential or commercial building facades. Titan Facade Panel cladding can be fixed over either timber frame or lightweight construction steel framed wall using a wide range of colours
• A medium density sheet that is back sealed for extra moisture resistance. • Sheet comes pre-primed to provide a stable base for paint. • 30 or 60 minute fire rated system can be achieved when installed as per the current James Hardie Fire and Acoustic Technical manual. • Titan Facade Panel is resistant to fire and to damage from moisture and rotting when installed and maintained correctly. • Board warranty of 15 years.
The basic composition of Titan Façade Panel and the CLD® Structural Cavity Battens are Portland cement, ground sand, cellulose fibre and water. The product is easily identified by the name Titan Façade Panel on the rear face. Titan Facade Panel is sealed and primed on the face. The battens are factory sealed on all sides. Titan Facade Panels and CLD® Structural Cavity Battens are manufactured to AS/NZS 2908.2 ‘Cellulose-Cement Products’ Part 2 (ISO 8336 ‘Fibre-Cement Flat Sheet’). James Hardie New Zealand is an ISO 9001 ‘Telarc’ certified manufacturer. Titan Façade Panel and CLD Structural Cavity Battens are classified Type A, Category 3 in accordance with AS/NZS 2908.2 ‘Cellulose-Cement Products’ standard.
Properties at equilibrium condition • Thickness: 9mm • Approx. moisture content: 3% - 5% • Width tolerance +/- 1mm • Length tolerance: -4mm • Thickness tolerance: -0.2/+0.4mm • Diagonal difference +/- 3mm • Approx. mass: 13kg/m2 • Width: 1190mm • Length: 1400mm, 2700mm or 3000mm
As a guide, it is recommended that the basic normal maintenance tasks shall include, but not be limited to: • Washing down exterior surfaces every 6-12 months** • Re-coating exterior protective finishes* • Regular inspection and repair if necessary of the facade panels, sealants, Butyl and Inseal strips etc. • Cleaning out gutters, down pipes and overflow pipes as required. • Pruning back vegetation which is close to or touching the building as well as ensuring the NZBC ground clearance requirements are maintained especially where gardens are concerned. • The clearance between the bottom edge of the Titan Façade Panel cladding and the finished/unfinished ground must always be maintained. • Refilling the countersunk holes where the cracks start appearing in the paint film around epoxy fillers or where fastener read through becomes significant. *Refer to the paint manufacturer for washing down and recoating requirements related to ongoing paint performance. **Do not use a water blaster to wash down the cladding.
|
You are viewing product 1 of 0 Next >
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
