|
 |
 | |
|
|
|
| |
|
|
| |
| ||
|
|
| |
|
|
| |
|
|
Home > Finish > Painting and paperhanging > Interior Painting > Interior painting - plasterboard and fibrous plaster Resene Waterborne Smooth Surface Sealer - Adhesion Primer - Exterior / Interior - Waterborne Resene Waterborne Smooth Surface Sealer has been tailored to be a waterborne ’adhesive primer’ over a series of surfaces usually considered difficult to coat or in need of expensive pretreatment. Fast drying, easy application and wide compatibility with topcoats are added features of this product.Key Properties: VOC: less than 10 Usual no. of coats: 1 Environmental Choice approved: Yes Made in New Zealand: Yes 100% NZ Owned and Operated
View Product Certifications View Potential Green Star credits
Typical uses: As a pre-treatment on • Aluminium • Baked enamels • Copper and its alloys • Glass and ceramics • Laminated surfaces • Melamine • Most glazed surfaces • Old varnished surfaces Application: Apply by spray, brush, speed brush or roller. Light bubbling may occur with some rollers and will require laying off. See Resene Data Sheet D47a and product label for full details. Limitations: 1. Resene Waterborne Smooth Surface Sealer is not designed to give long-term exterior protection without overcoating. Durability of up to three months may be expected in mild marine conditions or better. 2. The system will usually attain maximum adhesion after several days. 3. Might not adhere to all plastics. A test patch is recommended
• Rapid dry time. • Unsurpassed adhesion over a variety of nonferrous surfaces. • Useful over plastics, such as Formica® laminates. • Compatible with all topcoats tested. • May be overcoated within two hours with waterborne topcoats. • An Environmental Choice approved product. Unwanted paint and paint containers can be returned to the Resene PaintWise paint and paint packaging recovery programme. Returns are donated to community groups, sent to solvent recovery, packaging is recycled and other paint goes into covering graffiti and research on alternative uses. See link to Resene PaintWise.
Physical properties: Vehicle type: Auto oxidative Pigmentation: Titanium dioxide/chemically resistant extenders Solvent: Water thinned Finish: Low sheen Colour: Pale blue Dry time: Touch: 30 minutes Recoat time (minimum): 2 hours – waterborne paints, 4 hours – solventborne products, such as Resene Uracryl 403 (see Resene Data Sheet RA56) and Resene Imperite I.F. 503 (see Resene Data Sheet RA81); always use Resene Enamel Undercoat (see Data Sheet D44) before topcoating with solventborne paints. Theoretical coverage: 12 sq. metres per litre Usual no. of coats: 1 Abrasion resistance: Good Chemical resistance: Good Solvent resistance: Good Durability: See limitations Thinning and clean up: Water when wet; Resene Brush Clean when dry VOC: less than 10 grams per litre
Resene products are guaranteed to provide film integrity and adhesion for the expected life of the paint system. See the link for a full copy of the Resene Promise of quality, which includes details of the expected paint system life. Maintenance: Avoid cleaning the paint finish until at least four weeks after application time to ensure it has had sufficient time to fully develop its properties. Keep any cleaning to a minimum to avoid damaging the paint film. Follow the care and cleaning instructions in the Resene Caring for your paint finish brochure.
|
You are viewing product 1 of 0 Next >
| ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
